Elite SL-3000-UL Slide Operator

 


Commercial Slide Gate Operator (1/2 hp) for use in high traffic applications. Capable of continuous cycles daily.

The Sl-3000-Ul™ is smooth and exceptionally quiet. This unit can handle continuous cycles daily with gates up to 1000 lbs. and 37 ft. in length with a traveling speed of 12 inches per second. It is designed for high traffic applications such as heavily accessed gated communities and commercial buildings.

Electrical Specifications
120 VAC Power  
Built-in 120 VAC power receptacle (NEMA 5-15).
Alarm  
If the gate hits an object twice while opening or closing, the system will shut down and an alarm will sound for five minutes.
Alternate Outputs  
With Omni Option board, three push button command control, burglar alarm input and output. QCC option available.
Burglar Alarm  
With Omni Option board, interfaces with existing home alarm or alarm output.
Digital Motor Protection  
Entrapment sensor shuts off the motor after it reaches the stall amp for 3 seconds, reverses direction for several inches and stops.
Electronic Inputs  
Radio receiver, key switch, safety loop, center loop, telephone entry system, computer input, fire department key switch, and 3-push-button station.
ERD Sensor  
If the gate hits a vehicle while closing, it re-opens. If it hits a vehicle wile opening, it stops, reverses 4 to 6 inches, and stops again.
Gate Traveling Time  
Adjusted by a precision mechanical device and electrical limit switch system.
Integrated Loop Detectors  
Easy to install, modular, plug in loop detector inputs for exit loop, center loop, and safety loop.
Intelligent Master/Slave  
Precise, synchronized movement and communication between two gate operators using three wire RS-485 bi-directional technology.
Magnetic Lock  
With Omni Option board, magnetic lock system is incorporated, allowing easy addition of the MG1300 locking system to the gate.
Modular Board  
Uses LEDs to indicate all input and output functions of the gate operator.
Motor Drive  
Solid state electronic motor drive system is incorporated into the board.
Power Input  
Controls power input to the board with convenient switch.
Power Management  
Board includes electronic power management with over current shutdown and automatic recovery.
Soft Stop  
Gate travels through the cycle at normal speed and comes to a stop slowly for more accurate gate cycle. Equipped with integrated time delay for long mechanical life expectancy.
Spike Suppressors  
20,000 Amps and near lightning protection with modular Omni surge suppressor. Initial response time: 0.000000000001 seconds.
Three Push Button Control  
On board gate operator control for close, stop and open.
Timer  
Adjustable timer can be set from 0-60 seconds.

 

Mechanical Specifications
Approval  
UL and ETL listed to the latest UL325 and UL991 specifications.
Chassis  
Constructed with .25 inch sanded, welded, and gold zinc plated sheet metal.
Cover  
High density polyethylene plastic and stainless steel for excellent heat and corrosion resistance.
Cycles  
Capable of continuous cycles.
Dimensions  
Length = 18in x Width = 19in x Height 25in
Emergency Release  
The gate is easily disconnected by turning the release handle. the best option is our DC-1000SL.
Finish  
All metal parts are gold zinc plated for rust proof protection.
Gate Length  
37 feet maximum gate length.
Motor  
1/2 hp, instant reversing, 120VAC, 4 amp, 1625 rpm, with high speed ball bearings.
Output Shaft  
1 inch cold rolled steel.
Shipping Weight  
130 pounds.
Travel Speed  
12 inches per second average gate speed.
Weight  
112 pounds.
Weight Capacity  
1000 pounds maximum gate weight.
Worm Gear Reduction  
30-to-1 worm gear reduction in an oil bath.
Owner's Manuals
  SL3000UL
Mounting Plate- SL3000UL
SL3000UL ADDENDUM
© 2012 Compound Security Specialists. All Rights Reserved Site hosting and design by SiteStreet